DESCRIPTIONS
This fan is designed for bathroom, family steamer shower room, bedroom, hotel, office, etc. Fan is with thermal protection.
LOCATION & INSTALLATION CAUTIONS:
Assure the fan’s location to be as higher as possible. Minimum height should not be less than 2.3m from the ground.
Assure the fans to be installed opposite to the main sources of air-replacement with at least 30mm from the corner of wall and ceiling.
Assure the fans to be mounted as close to the sources of steams or odours as possible, but far enough from anyone using a bath or shower so not to be touched.
Avoid mounting directly over heated surface.
WALL INSTALLATION:
Cut an appropriate size hole in the wall; ensure there are no cables or pipes buried in the wall while cutting. Allow the duct to slope slightly to the external wall, this will allow drainage of any ingress from rains etc.
Remove the front cover of fan and position it against the wall and mark the four fixing points and cable entry.
Bring the main cable through the cable entry and fix the unit into position using suitable fixing screws to fix the fan.
Fix the front cover and then try to operate the fan to ensure if it is installed well.
GLASS-WINDOW INSTALLATION:
Remove the cover and position the fan against the window glass and mark the cable entry.
Bring the main cable through the cable entry and fix the fan body into position.
Use the glass glue to fix the fan body and let the glass glue dry for 3 minutes, then the fan will be firmly mounted in glass.
